Question:
i am trying to setup sld for newly installed sap system in my lab
http://help.sap.com/saphelp_nw04/helpdata/en/23/b557422d095542e10000000a1550b0/content.htm
i think my system is scenario-2 .
as i have ep sneak preview system installed on my single stem with good configuration .
it was running good for enterprise portal.
and i have r/3 system in the network .
i like to setup sld. so as to make connection between ep and r/3
in the above link it says.
first step go and run where sap netweaver administration system
1. i did that on the ep system
2. choose service ->sld services->http service (i did that)
3.but when ??? it comes to host and port of the ( Enter the Host and the HTTP port of the system to which your system will report the data..)
i am not sure abt the howt and port where do i need to look for that
and even what host name and port num i am supposed to get at the r3 system end .
it would of great help if some one can throw some light r help me to walk through that
https://www.sdn.sap.com/irj/sdn/weblogs?blog=/pub/wlg/2167-
i hope even this link helps as i followed all these steps
thanking you
prattipati
_________________
prattipati
Answer:
Maybe this helps:
Maintaining SLD Connection Parameters
1. Log on to the SAP System as user DDIC and call transaction SLDAPICUST.
The screen Maintain SLD Access Data is displayed.
2. Choose Display<-> Change, and then proceed as follows:
a. Choose Insert Row.
b. Enter the connection parameters to the SLD:
− Host Name: host name of the SLD host
− Port: HTTP port of the J2EE engine (The following naming convention applies: 5<J2EE_instance_number>00. 50000, for example, if your J2EE instance is 00).
− User
− Password. As user enter XIAPPLUSER
c. Set your entry as Primary. Only the Primary marked entry is active.
d. Save.
etc.
You find this in the installation guide for SLD
W11