Question:
Hello,
We have been experiencing a recurring dump in VT02N with error 'CONTROL_NOT_FOUND'. In the system log, the error details read as follows:
The termination occurred in the ABAP program "SAPLSPO5" in "%_CTL_OUTPUT"
The main program was "SAPMV56A ".
The termination occurred in line 30 of the source code of the (Include) program "<SYSINI>" of the source code of program "<SYSINI>" (when calling the editor 300).
This is the code extract from program SAPMSSYD where the dump supposedly occurred:
000270 * Nach DCO
000280 module %_CTL_OUTPUT output.
000290 perform %_CTL_OUTPUT in program SAPMSSYD using SY-REPID if found
--------> endmodule.
The activities in VT02N when these dumps happend are detailed below:
Enter shipment #-execute
Uncheck planning
Look for delivery #
Minus out delivery#
Save (when saving it takes you back to the beginning of vt02)
Enter
Check planning (this is where it sometimes will not check and it will freeze and will take us to an error message)
What confuses us is this error does not always happen when the process above is done. Until now, we are unable to replicate the dump at will, though it still happens frequently. And we cannot identify what causes them
Could someone help us figure out why this is error is happening?
Thanks a lot for you help.
Best Regards,
Gladys
Answer:
Sounds like you have GUI issues. What version of the GUI are you running? Do you have the latest patches installed for your current version? Have you run any traces or checked OSS? Have you tried re-installing the GUI?
_________________
Swim, Bike, Run