Question:
hai all,
i have to load data from cube to another cube. so i have taken all the necessary steps for this. i.e.
1. exported the data source for the source cube.
2. replicated the datasources.
3. activated the communication structure.
4. created and activated the updated rules.
but the problem is i am getting zero records from the source cube, even it has got 5000 records.
for your info there no error requests which are marked yellow or red for this cube and also there are no aggregates associated with this cube.
the message i am getting is
No data available
Diagnosis
The data request was a full update.
In this case, the corresponding table in the source system does not
contain any data.
System response
Info IDoc received with status 8.
Procedure
Check the data basis in the source system.
Answer:
Hi,
Are there any settings in your Update Rules or InfoPackage that could be restricting the data? For Example, are you trying to select data for a certain date when there is no data for this date. There is probably a number of causes but this may be worth checking.
Answer:
hi,
loading from cube to cube is always a bad idea...tell u why...with each upgrade, things change. if u r using an MDX to do this maybe its fine.
if u want to load the data from a cube to another cube, u might as well use the same infosource to load to the final target.
zork