Question:
When I click the button "InfoCube Content" at "Administrator workbench" Open a infoPackage about material ",then the BW system make a mistake
"Settings for material number conversion not",Can you tell me why?
_________________
Contact me: sapabap@hotmail.com
Answer:
Well, I hope that I do understand your question in the right way. There's an error within the conversion of at least one attribute of the info object material. Had this myself. You should check the data load of the infopackage in the psa, filter the records by red status. Then you see which records didn't fit. If you couble-click onto one of the records you get further details. Maybe you have to maintain the permitted characters (so it was in my case, because needed tthings like ü, ä...), the transaction to maintain the permitted characters is RSKC.
Hoping this will help you.
Juergen
_________________
Juergen Limbach
Answer:
Hi,
I just had the same error. Refer to note 555675
The settings for the material number in R/3 are not the same as in BW. In BW. Use transaction OMSL in BW. To see the settings in R/3, use OMSL as well.
good luck.
Answer:
Hu.
Yes, that's the rigt way....
RSKC I had to do with customers... Now I remember...
I'm sorry for the wrong information I gave yesterday...
_________________
Juergen Limbach
Answer:
thank you!
_________________
Contact me: sapabap@hotmail.com