Question:
Hi All,
I have recently attempted to activate a variety of infoobjects. I am experiencing a variety of errors. One is message R7245 (Infoobject XXX does not exist in version A) which I have tracked down to OSS note 700378. Howver, the other error (or lack of it) is that after successfully installing some infoobjects, they do not appear in the Modelling area. All indications point that these objects were not installed at all (no SID, MD, and text tables). The log for installation points to green for both direct and batch installation.
Has anyone experienced the same problem? Will OSS 700378 solve problem #2?
Regards,
EL
Answer:
Could You say what relase of BW you use. I had the same problem half year ago with 31C BW version - the problem was the same but it depends also on patch level you use. In my case 11 patch level were needed.
Answer:
Could You say what relase of BW you use. I had the same problem half year ago with 31C BW version - the problem was the same but it depends also on patch level you use. In my case 11 patch level were needed.
Best regards
Andy
Answer:
/forums/viewtopic.php?p=193813&highlight=#193813
for me source code correction worked
and to populate all the infoobjects under the rite catalogue u gotta install respective INFOOBJECT CATALOGUE
Hope it Helps
_________________
Chetan
@ CP...
Answer:
Thanks all for your suggestions. I have applied source code corrections according to note 656282 and it fixed both problems. I can finally activate 0REPTT and after activating that, the other infoobjects magically appeared.
Chalk it up to another confusing BW moment.
Regards,
EL