Question:
hi,
I have problem on outbound PO,
I am using the msg type ORDERS to generate the NEW PO (this is ok)
and try to activate the msg type ORDCHG to handle the PO Changes.
I use the same Output Type for the ORDERS & ORDCHG (ZUB1), the diff is on the ORDERS I used ME10 as Process Code.
and on ORDCHG I used ME11 and ACTIVATE the Change Message Flag.
the NEW PO creation work fine with above config. but the ORDCHG is not trigger at all, even the PROCESSING LOG didn't show me any problem.
I check SPRO - the Fields Relevant to Printouts of Changes, and it's ON.
Did I miss some config?
regards,
Becak
Answer:
don't worry guys, I found the solution on my previous problem.
regards,
becak
Answer:
Hi Becak,
I'm presently facing with the same problem.
I set two differents output types NEU & ZNEU. I set ZNEU as triggerable along with modification operation. I check all spro points.
Determination analysis shows it finds good access but the message is not set !!!
Any clue to help me ?
Thanx